1, the installation of single-hole basin faucet

When buying face basin bibcock of single handle, should notice to go to water mouth diameter, at present the majority on the market is hard tube enters water, notice to reserve conduit height, had better be about 30 inside from stage basin downward.When installation, must choose to match the special Angle valve, Angle valve must be fixed with the wall outlet cold hot water pipe.If there is a distance between the Angle valve and the faucet on the pipe, you need to buy special pipe to lengthen the link.Do not use other water pipes to connect, otherwise the water will leak and fall off due to the large water pressure.If the inlet pipe is too long than the outlet pipe, cut off the excess.

Note: do not bend the pipe hard to 90 degrees or more.When installing basin to go water, please do not forget to buy the small interface of bibcock (bibcock short connection).Water pipes buried in the wall must be flushed in advance before installation.

2. Installation of shower and Bathtub faucets

If buy shower, bath, hang wall bibcock, that needs to choose appropriate height buries out conduit.Hot and cold water pipes are about 20 miles away.Flush the water pipe before installation to avoid damage to the faucet due to hard water quality.

Dark outfit shower, bath crock bibcock: after buying dark outfit bibcock, want to bury the valve core of bibcock commonly inside the wall.The thickness of toilet wall should be considered before pre-burial.If the wall is too thin, the valve core will not be embedded.Embedded when the valve core plastic protective cover do not easily remove, so as not to damage the valve core in embedded cement and other chores.In addition, when the embedded valve core should also pay attention to the valve core up and down, about the direction, so as to avoid the valve core buried wrong.

3. Installation of thermostats

Before installing constant temperature faucet, check which side of the next water pipe is cold water, which side is hot water, especially the cold and hot water pipe connected wrong, so as not to affect the future work of the faucet.Gas and solar water heaters cannot use thermostats, mainly because the water pressure is too low.Install thermostats and hot and cold water filters.

4. Installation of single hole kitchen faucet

Because the kitchen bibcock is used frequency is taller, move again move go loose extremely easily, all requirement is firm be taken for granted, because this lock nut must tighten.At present, building materials market has a batch of bibcock to enlarge the screw tube that nut fixes, super good firm effect.The obvious effect will be the trend of the generation trend.